Installation Guide
5. Setting flame
There are 6 brightness levels that can be selected
work.
Settings 1 -3 increase in brightness with flicker.
Settings 4 -6 increase in brightness without flicker.
MAINTENANCE
1. Turn off the heater of the power switch.
2. Unplug the unit and let it cool completely.
3. To keep the heater clean, the outer shell may be cleaned with a soft, damp cloth. You may use a mild
detergent if necessary. After cleaning, dry the unit with a soft cloth. CAUTION: DO NOT let liquid
enter the heater.
4. DO NOT use alcohol, gasoline, abrasive powders, furniture polish, or rough brushes to clean
the heater. This may cause damage or deterioration to the surface of the heater.
5. DO NOT immerse the heater in water.
6. Wait until the unit is completely dry before use.
TROUBLE SHOOTING
IF YOU EXPERIENCE DIFFICULTIES, PLEASE DO NOT RETURN THIS PRODUCT TO STORE
For assistance with this appliance, please call our customer service department.
PROBLEM
POSSIBLE CAUSE
SOLUTION
The overheat protection device
Turn all controls off, unplug
No warm air is coming from the
the appliance, allow to cool for
in the appliance has been
heater
at least 10 min plug back in and
triggered.
restart.
The overheat protection
Turn all controls off, unplug
The appliance turns off and will
device in the appliance has
the appliance, allow to cool for
been triggered.
at least 10 min., plug back in
not turn back on.
The appliance does not turn on
The overheat protection device
Turn all controls off, unplug the
appliance, allow to cool for at
when the button is pushed to
in the appliance has been
least 10 min., plug back in and
“ON”
triggered
restart.
~ 7 ~