09.142 109.
GB USE AND MAINTENANCE MANUAL Pag. 1 CONTENTS CHAP.1 INTRODUCTION............................................................................................................. 3 CHAP.2 INSTALLATION .............................................................................................................. 3 2.1 2.2 2.3 2.4 2.5 2.6 2.7 2.8 HANDLING AND UNPACKING ............................................................................................... 3 ELECTRICAL CONNECTION ...................
Pag.
GB USE AND MAINTENANCE MANUAL CHAP.1 Pag. 3 INTRODUCTION The warnings contained in this manual provide important information for safely installing, using and servicing this machine. The operator is required to read this manual before starting any operation involving handling, installation, use, maintenance or disassembly of the machine. This manual must be kept intact and in a safe place for frequent consultation. CHAP.2 2.
USE AND MAINTENANCE MANUAL Pag. 4 GB H 2.2 ELECTRICAL CONNECTION 1. Connection to the power supply must be made with a main switch (H) it must be omnipolar and interrupt all contacts including neutral. There must be a distance of at least 3 mm between open contacts, and it must have a thermal magnetic safety switch or fuses which are able to withstand the maximum power indicated on the plate. 2.
GB USE AND MAINTENANCE MANUAL Specification Hardness Residual Minerals Pag. 5 From To French degrees f 5 10 German degrees °dH 4 7’5 English degrees °e 5 9,5 Parts per million ppm 70 140 Maximum mg/l 2.4 300/400 CONNECTION TO THE DRAIN LINE The tank empties by gravity, so the drain needs to be situated below the base of the machine. The drain pipe needs to be connected to a drain- trap built into the floor. The drain dimensions are shown in the installation drawing. 2.
GB USE AND MAINTENANCE MANUAL Pag. 6 Set washing tank temperature: Press A push-button several times until wording “ t ” “55” is displayed; then adjust it by means of G and L push-buttons. Once the temperatures have been set, just hold push-button A pressed to return to the previous condition. 2.6 RINSE AID DISPENSER ADJUSTMENT (for dishwashers with hydraulic dispenser, only) A Before adjusting, the dispenser and hose need to be filled using the primer button (A).
GB USE AND MAINTENANCE MANUAL Pag. 7 The above amounts are for water with a hardness of 5-10°F (French degrees). 2.8 DETERGENT QUANTITY ADJUSTMENT (Dishwasher with detergent dispenser, to be adjusted via a trimmer) Adjustments: Turn trimmer (A) to define the switching on / switching off time, and consequently also the quantity of detergent to be used. • • A Turning the adjustment trimmer clockwise or counter-clockwise will respectively decrease or increase the amount of rinse aid it delivers.
Pag. 8 USE AND MAINTENANCE MANUAL GB In the second dial the display shows the set value in seconds; it is possible to increase or decrease the switching time through L and G push-buttons. Note: The point indicates ½ second. Rinse aid Once the detergent has been adjusted press push-button "A" once again to pass to the following item and to display "bL" rinse aid. Press push-buttons "L" and "G" to increase or decrease the switching time. CHAP.3 3.
GB USE AND MAINTENANCE MANUAL 3.3 Pag. 9 VIEWING THE NUMBER OF WASHING CYCLES CARRIED OUT The number of washing cycles performed can be displayed. Just press push-button L for a few seconds and the display will show the figure, as indicated in the picture The display first shows thousands and hundreds, then tens and units. 3.4 Display message do Function description One of the machine doors is open. b t No dL Rinse water temperatures. Washing water temperature. Detergent missing.
USE AND MAINTENANCE MANUAL Pag. 10 “Er. 03” “Er. 04” The boiler temperature did not reach the set point within the extension of Thermostop timeout the operating cycle washing phase. The boiler heating is disabled. Contact the authorised service centre. Water level inside the washing tank not reached. Turn the machine off Tank loading and on, make sure that the overflow pipes are fitted correctly and timeout that water supply is open, otherwise contact the authorised service centre. “Er. 05 Er 06” “Er.
GB USE AND MAINTENANCE MANUAL CHAP.4 4.1 Push-button / warning A Function Machine on / off push-button. B Line warning light on. C Washing temperature display. D E Rinse temperature display. Machine ready for use warning light. Automatic start enabled warning light. Cycle start push-button. F G H I L M N O Q 2-minute programme warning light. 4-minute programme warning light. Washing programme selection push-button. 6-minute programme warning light. 12-minute programme warning light.
USE AND MAINTENANCE MANUAL Pag. 12 4.2 GB USE INSTRUCTIONS 1 1. To turn the machine on, press the button indicated at left/right (the corresponding warning light will light up). 2 2. The machine is ready to use when the light comes on. (Red = heating in progress). Short cycle Medium cycle 3 Intensive cycle 3. Press the side key to select washing time. The warning light corresponding to the selected product will come on. Note: select “∝” programme for prolonged washing cycles. 4 4.
GB USE AND MAINTENANCE MANUAL Pag. 13 5 5. To carry out washing cycles starting when hood is closed, press the indicated side key, and the corresponding warning light will come on. 1 4.2.1 AUTOMATIC WATER DRAIN IN TANK (OPTIONAL) 1. Press the button indicated at left/right and select the drainage programme (the corresponding warning light will light up). 2. Press the button shown to the side and the machine automatically drains the water in the tank. 2 4.
Pag. 14 GB USE AND MAINTENANCE MANUAL detergent and electricity only wash when the baskets are full, but do not overload them. Avoid stacking glassware. • WE RECOMMEND TO PRE-CLEAN the glassware in order to minimize maintenance. The quality of final wash results will be greatly improved by first removing food particles, lemon peels, toothpicks, olive pits, etc. which could partially clog the pump filter and impair washing efficiency.
GB USE AND MAINTENANCE MANUAL Pag. 15 REMARK: Do not wash the equipment with direct jet or at another pressure because eventual infiltrations to the electric components may harm the regular working of the equipment or of the single safety systems, and penalty for this would be the loss of guarantee. CHAP.5 MAINTENANCE 5.1 GENERAL RULES The machine are designed to reduce maintenance requirements. It is necessary to observe the following rules to make the machine last long, and work without problems.
Pag. 16 USE AND MAINTENANCE MANUAL GB • Lime deposits and scale will build up on the inner surfaces of the boiler, tank and pipelines due to calcium and magnesium salts present in the water. These scales and deposits can prejudice proper apppliance operation. • The appliance must be periodically descaled and we recommend that this must be done by an expert. • Grease steel surfaces with vaseline oil whenever the appliance will be inactive for a long period of time.