Installation Guide

Slide the jamb wiper vinyl [B] into the pivot

jamb [C]. A small amount of soapy water will help

installation. Cut the jamb wiper vinyl 7/8” shorter than

the pivot jamb to allow room for the pivot brackets [D].

Fit one of the pivot brackets into the bottom of the

pivot jamb. Lock it in place with a #6 x 3/8” truss head

screw [E] and a #8-32 x 1/8” set screw [F] (a 5/64”

Allen wrench [G] is provided).

NOTE: Set screws (F) are pre

-installed

Place the pivot jamb [C] on the curb [A] with

the exterior face lined up with the raised edge of the

curb. Use a level to plumb the jamb then mark the

mounting hole locations. Remove the jamb and drill the

mounting holes.

For tile or marble walls, drill three 7/32” diameter holes

and insert the plastic wall anchors [H]. A center hole

punch helps locate the holes accurately. Attachments to

fiberglass or acrylic units can be made in two ways.

reinforcement is built into the wall of the unit, drill

three 1/8” diameter holes to install mounting screws

directly into the reinforcement. If walls are not

reinforced, drill 7/32” holes and install plastic wall

anchors or Molly bolts (Molly bolts are not supplied)

Replace the pivot jamb and attach to the wall with three

#8 x 2” truss head screws [J].

Thread the two #10-24 x 7/16” square head set

screws [K] into the tapped holes in pivot blocks in the

top and bottom rails of the glazed door panel [L].

Measure the distance from the wall to wall directly

above the curb (Dim. “A”). Deduct 3 13/16” from this

amount and position the pivot pins this exact distance

(Dim. “B”) from the edge of the door. Tighten the set

screws just enough to prevent the pivot blocks from

moving (finger tight plus

a quarter turn). A 3/16”

wrench (not supplied) will fit the set screw heads.

QCI5001 Rev 0 Page 5 Certified 06/21/2016