Installation Guide

Using a 3/16” drill bit, drill the interior face of the header
assembly on both ends as shown. These holes may be
predrilled from the factory.
7
Press the header assembly [D] over the wall
jambs [E], the 135° posts [J] and the pre-glazed panels.
Check the posts for plumb. Adjust as required by varying
the overlap of the header over the wall jambs. You may
need to trim the ends of the header where it meets the
wall. The minimum horizontal dimension for the door
opening is the door panel width (see the graphic in Step
#9) plus 1/2”, maximum is the door panel width plus
1 3/4”.
Using the holes in the ends of the header and curb as a
guide, drill four 1/8” holes into the wall jambs. Drill 1/8”
holes thru the header and curb into each 135° post as
shown, then enlarge the outer holes with a 3/16” drill for
clearance on the self-tapping screws. Secure the header
and curb to the wall jambs and posts with eight #8 x 1/4”
truss head screws [C].
8
Strip two clear vinyl jamb seals [K] into the door
panel [L] splash guard and the pivot jamb [M] and trim
flush at both ends. Both vinyls should be turned to trap
water from the shower head. Secure the vinyls with a
small quantity of glue or caulk at each end or by carefully
crimping the vinyl pocket. Set the door panel aside.
Press the pivot jamb and strike jamb [N] (with magnetic
strip) over the two 135° posts [J]. Refer to Step #1 for the
proper handling of the door.
NOTE: The magnetic strip on the strike jamb must face
the exterior and the clear vinyl jamb seal on the pivot
jamb must face inward.
9
INTERIOR
3/8”
1/4”
HEADER
ASSEMBLY
3/16” DIA.
MEASURE AT TOP OF
JAMBS AND POSTS
HEADER
ASSEMBLY
OPENING
1/4”
1/4”
CURB
ASSEMBLY
135
POST
WALL
JAMB
INTERIOR
JAMB
SEAL
PRE-GLAZED
PANEL
PIVOT
JAMB
MAGNETIC
VINYL
PIVOT
JAMB
SPLASH
GAURD
STRIKE
JAMB
GLAZED
DOOR
PANEL
JAMB
SEAL
DOOR PANEL WIDTH
135
POST
QCI0012 REV. 1 Page 6 of 9 Certified 07/06/05