Installation Guide

Attach the interior door handle [BB] and the

exterior door handle [CC] to the door panel [L] with

two #6-32 x 1 1/4” round head screws [DD].

Close the door and check the clearance with the strike

jamb [N]. If necessary, loosen the set screws [W] on

the top and bottom slide bars and adjust the door panel

to align the strike magnets. When the door panel is

properly aligned, tighten the set screws securely.

Carefully caulk the interior jamb-to-wall and

curb-to-base joints. Caulk the small gaps at the corners

of the side panels (see arrow on illustration) to prevent

water infiltration. For appearance, you may wish to

caulk the exterior joints as well.

We recommend you wait twenty-four hours before the

first shower to allow the caulking to cure properly.

Peel off the backing on the BASCO decal

[EE] and apply to the inside surface of the header.

(2) HANDLE

SCREWS

INTERIOR

HANDLE

DOOR

PANEL

INTERIOR

HANDLE

EXTERIOR

HANDLE

EXTERIOR

HANDLE

MAGNETIC

VINYL

STRIKE

JAMB

1/8”

IDENTIFICATION

GROOVES

STRIKE

RAIL

CAULK

Note: Do not caulk over weep holes

INTERIOR FACE

OF HEADER

DECAL

QCI0012 REV. 1 Page 9 of 9 Certified 07/06/05