Installation Guide

Press the four rail end caps [AA] into the

ends of the top and bottom door rails. A small dab of

clear silicone will hold caps in place.

Peel the backing from the BASCO decal [BB] and

apply it to the pivot jamb as shown in the detail.

NOTE: Do not use a metal hammer to install the

end caps.

Neatly caulk the inside perimeter of the

shower curb and the pivot and strike jambs.

NOTE: The caulking should be allowed to cure for

twenty-four hours before using your new shower

enclosure.

QCI0020 Rev. 0 Page 8 of 8 Certified 12/13/06

Interior