Installation Guide

MOLDED
BUMPER
WALL
JAMB
SCREW &
SPACER
INSERT
TUB
TRACK
GLAZED
PANELS
CENTER
GUIDE
INTERIOR
(2) #6 X 3/8 “
PAN HEAD
SCREW
Locate the nylon bottom guide [S] in the
middle of the tub track [A] with the glass panels in the
position shown. With a 7/64” bit, drill two holes into
the V-groove through the mounting holes in the guide.
Install the bottom guide with two #6 x 3/8” pan head
screws [T] thru the drilled holes as shown.
10
Slide the stainless steel bumper inserts [U] into
the four soft vinyl jamb bumpers [V]. Align the slots in
the bumpers with the glass panels and snap the bumpers
downward over the top and bottom wall jamb screws
[D] with the spacers [E].
11
CAULK
CAU
WALL
JAMB
TUB
TRACK
Neatly caulk each end of the tub track [A]
where it meets the wall jambs [B] and the interior edge
of the wall jambs as shown. Run a bead of caulking
along the interior edge of the tub track.
NOTE: The caulking should be allowed to cure for
twenty-four hours before using your new bath
enclosure.
12