Installation Guide

Insert a nylon pivot bushing [M] into the

bottom pivot bracket [D]. Slip the second pivot bushing

over the top pivot pin on the door panel. Position the

door by inserting the bottom pivot pin into the bottom

pivot bracket. Hold the door vertical and slide the top

pivot bracket into the pivot bushing. Secure the top

pivot bracket with a #6 x 3/8” truss head screw [E] and

a #8-32 x 1/8” Allen set screw [F].

Your Pivot Door is equipped with a magnetic

catch. Attach the strike jamb [N] to the door. Close the

door so the strike jamb is 7/8” from the front of the

curb [A] and mark the jamb location on the wall. If the

curb is not used, close the door parallel to the shower

sill and mark the jamb location. Remove the strike

jamb from the door, hold it in the marked location and

mark the hole locations for the mounting screws. Drill

the mounting holes per the instructions in Step #5.

Replace the strike jamb and attach it to the wall with

three #8 x 1 1/2” flat head screws [P].

Close the door and check the clearance with the strike

jamb. If necessary, loosen the set screws [K] on the top

& bottom slide bars and adjust the door panel to align

the magnets. When the door panel is properly aligned,

tighten the set screws securely.

Attach the interior door handle [R] and the

exterior door handle [S] to the door with two #6-32 x 1

1/4” round head screws [T].

MAGNETIC

LATCH

STRIKE

JAMB

STRIKE

RAIL

IDENTIFICATION

GROOVES

I NTERIOR

HANDLE

EXTERIOR

HANDLE

#8 X 1 1/2"

SCREW

QCI5001 Rev 0 Page 6 Certified 06/21/2016