Installation Guide
INDENTIFICATION GROOVE
NOTE : Each magnetic strip has an indentification groove on the exposed
surface. For proper alignment, the grooves should be opposite
each other (see detail).
Identification Groove
MAINTENANCE: Two primary materials are used to manufacture your new enclosure: tempered
glass and anodized aluminum. To assure a long lasting finish on the enclosure, wipe it down with a towel after
each use. Never use a scouring agent to clean the aluminum.
For occasional, more concentrated cleaning efforts, we find that
works extremely well. Be sure that any over spray falling on the aluminum frame is rinsed thoroughly and
dried. Many over-the-counter cleaners, if applied to the aluminum and left on, will h
arm the metal finish and
cause permanent damage, even though their directions indicate safe use on shower doors.
INSTALLATION NOTES: Unpack your unit carefully and inspect for freight damage. Lay out and identify
all parts using the instruction sheets as a reference. Before discarding the carton, check to see that no small
hardware parts have fallen to the bottom of the box. If any parts are damaged or missing, refer to the
descriptions noted in the instructions when contacting your dealer for replacements.
Ha
ndle the glass panels carefully and protect the edges. Safety tempered glass is very resistant to breakage, but
the sharp corners of the panels can damage tile and floor surfaces.
Please wear safety glasses whenever drilling or cutting. When drilling holes in the ceramic tile or marble, use a
center punch and hammer to carefully break the surface glaze so the drill can start without skidding.
To install your you will need the following: tape measure, level, #2 Phillips screwdriver,
drill, 3/16” wrench, 1/8” and
3/16” drill bits, hacksaw, pencil, and caulking (clear silicone recommended).
Optional tools include a miter box for cutting parts to length, files, center punch, and masking tape.
NOTE: Tempered glass cannot be cut.
Although safety tempered glass is very resistant to breakage, the glass can still
- idda nI .noituac esU .noitallatsni gnirud ti no decalp si erusserp lauqenu fi kaerb
tion, the sharp corners of the panels can damage tile and floor surfaces, so it is best
to handle the glass panels carefully and protect the edges.
shower
Lysol Bathroom Cleaner
new shower door
QCI5029 Rev 0 Page 2 Certified 06/21/2016