Installation Guide

Press the header [H] over the wall jambs [B]
and the 180° post [G]. Plumb the post, moving it
laterally as required to maintain proper coverage on the
fixed glass panel [F]. The minimum horizontal
dimension for the door opening is the door panel width
(see the graphic in Step #8) plus 1/2”, maximum is the
door panel width plus 1 3/4”. Using the holes in the
ends of the header and curb asaguide, drill four 1/8”
holes into the wall jambs. Drill two 1/8” holes thru the
header and curb into the 180° post as shown, then
enlarge the two outer holes with a 3/16” drill
for
clearance on the self-tapping screws. Secure the header
and curb to the wall jambs and 180° post with six #8 x
1/4” truss head screws [J].
CAUTION: Slide the glass panel away from the wall
jamb before drilling to prevent damage or breakage.
7
GNI NE PO
3/8”
(6) #8 X 1/4”
SCREWS
1/4”
1/4”
Strip two clear vinyl jamb seals [K] into the
door panel [L] splash guard and the pivot jamb [M] and
trim flush at both ends. Both vinyls should be turned to
trap water from the shower head. Secure the vinyls with
a small quantity of glue or caulk at each end or by
carefully crimping the vinyl pocket. Set the door panel
aside.
Press the pivot jamb and strike jamb [N] (with
magnetic strip) over the wall jamb [B] and 180° post
[G]. Refer to Step #1 for the proper handling of the
door.
NOTE: The magnetic strip on the strike jamb must
face the exterior and the clear vinyl j
amb seal on the
pivot jamb must face inward.
8
GLAZED
DOOR
PANEL
VINYL
SEAL
SPLASH
GUARD
PIVOT
POINT
MAGNETIC
VINYL
180
POST
STRIKE
JAMB
INTERIOR
VINYL
SEAL
PIVOT
JAMB
WALL
JAMB
DOOR WIDTH PANEL
Snap the fillers [P] into the curb [A] and header
[H] between the door jambs with the RAISED LIP TO
THE EXTERIOR and the pivot holes toward
the pivot jamb. Center the curb filler in the curb
between the pivot and strike jamb (use masking tape to
hold in position).
NOTE: The snap-in-filler should be exactly 3/8”
longer than the door panel width.
9
EXTERIOR
FILLERS
PIVOT
JAMB
WALL
JAMB
CURB
FILLER
HOLE FOR
PIVOT
BUSHING
HEADER
QCI5004 Rev 0 Page 6 Certified 06/21/2016