Installation Guide

1/4”
1/4”
3/8” - 3/4”
(6) #8 x 1/4
SCREWS
1 3/8”
Pull the bottom of the pivot jamb [M] tight to
the curb filler [P] and plumb the jamb. Drill two 1/8”
holes thru the pivot jamb and into the wall jamb [B]
3/8” to 3/4” from the wall and approximately 1/4”
vertically from the ends of the jamb. Drill a third hole
centered between the first two and enlarge the outer
holes with a 3/16” drill for clearance on the self-tapping
screws. Attach the pivot jamb permanently with three
#8x1/4” truss head screws [J].
Slide the header filler [P] tight against the pivot jamb.
Push the strike jamb [N] tight against the f
illers top and
bottom. With the pivot jamb plumb and both fillers
tight between the two door jambs, the strike jamb also
will be plumb and parallel to the pivot jamb. Attach the
strike jamb to the 180° post [G] in the same manner as
the pivot jamb.
10
0
Insert the two #10-24x7/16” square head set
screws [W] into the threaded holes in the pivot blocks
in the top and bottom rails of the glazed door panel [L].
Position the pivot pins 1 1/2” from the pivot side of the
door (the side opposite the magnetic strip). Tighten the
set screws just enough to prevent the pivot blocks from
moving (finger tight plus a quarter turn). A 3/16”
wrench will fit the set screw heads.
Press the white nylon spacer [X] over the bottom pivot
pin on the door panel.
11
PIVOT PIN
NYLON
SPACER
DOOR
PANEL
PIVOT BLOCK
SPLASH GAURD
SET SCREW
1 1/2”
1 1/2”
Insert the two nylon pivot bushings [Y] into
the pivot holes in the head and curb fillers [P].
Lift the door panel [L] and insert the top pivot pin into
the pivot bushing in the header filler. Hold the door
vertical and insert the bottom pivot pin into the pivot
bushing in the curb filler. It may be necessary to
remove the header retaining the screws and raise the
header slightly to install the door.
When the door has been set into place, snap the security
washer [AA] over the top pivot pin to hold the upper
pivot bushing in place and prevent accidental
dislodging of
the door.
12
HEADER
SAFETY
WASHER
DOOR
PANEL
NYLON
SPACER
SNAP-IN
FILLER
PIVOT
BUSHING
CURB
QCI5004 Rev 0 Page 7 Certified 06/21/2016