Installation Guide

Attach the interior door handle [BB] and the
exterior door handle [CC] to the door panel [L] with
two #6-32x1 1/4” round head screws [DD].
Close the door and check the clearance with the strike
jamb [N]. If necessary, loosen the set screws [W] on
the top and bottom slide bars and adjust the door panel
to align the strike magnets. When the door panel is
properly aligned, tighten the set screws securely.
15
(2) HANDLE
SCREWS
INTERIOR
HANDLE
DOOR
PANEL
INTERIOR
HANDLE
EXTERIOR
HANDLE
EXTERIOR
HANDLE
MAGNETIC
VINYL
STRIKE
JAMB
1/8”
PIVOT
SIDE
11/16”
STRIKE
SIDE
TAPE
DRIP
RAIL
DRIP
VINYL
BOTTOM
RAIL
(ALIGN)
Clean the bottom door rail and the drip rail
thoroughly with rubbing alcohol to ensure proper
adhesion. Unroll the double stick tape [V] and carefully
apply it to the back of the drip rail (do not peel the tape
backing yet).
Insert the tapered drip vinyl [T] into the drip rail.
Position the drip rail flush with the bottom and pivot
side of the door panel [L], then raise the strike side
until the bottom edge of the drip vinyl is parallel to the
curb [A]. Mark the location of each end of the drip rail.
13
BREAK
APART
DRIP RAIL
DRIP
PLUG
DRIP
VINYL
TAPERED
DRIP VINYL
1/4”
1/16”
Adjust the drip vinyl [T] by sliding it left or
right until it almost touches the curb. Trim the vinyl
(flush with the pivot end and notch 1/4” longer than the
drip rail as shown on the strike end).
The drip plug [S] is supplied with a left and right hand
plug together. Break the right and left drip plug apart
and insert the appropriate plug into the high (strike)
side of the drip rail. Discard the unused drip plug. Peel
off the tape backing and carefully press the drip rail [R]
to the door in the marked position.
NOTE: Cleaners with alcohol content can dissolve the
adhesive that attaches the drip rail. To prevent this
possibility, place a small bead of clear sealant at the top
of the drip rail where it is attached to the bottom rail
.
14
QCI5004 Rev 0 Page 8 Certified 06/21/2016