Installation Guide

Page 2
Before You Start
Cered 4/21/2015
QCI0288
Check Your Box
Unpack your unit carefully and inspect
for freight damage. Lay out and idenfy
all parts using the instrucon sheets as a
reference. Before discarding the carton,
check to see that no small hardware
parts have fallen to the boom of the
box. If any parts are damaged or missing,
refer to the descripons noted in the
instrucons when contacng your dealer
for replacements.
Make Sure You Have Ready
 3/16” & 1/4” Drill Bits
 Drill
 Pencil
 Low Tack Masking Tape
 4’ & 6’ Levels
 #2 Phillips Screwdriver
 Caulk (Clear Silicone
Recommended)
 Caulk Gun
 Sucon Cups (Recommended)
 Center Punch (if drilling into
le)
Warning
Tempered glass cannot be cut.
Although safety tempered glass is very resistant to breakage, the
glass can sll break if unequal pressure is placed on it during
installaon. Use cauon. In addion, the sharp corners of the
panels can damage le and oor surfaces, so it is best to handle
the glass panels carefully and protect the edges.
Maintenance Notes
To assure a long lasng nish on the enclosure, wipe it down with a
towel aer each use. Never use a scouring agent to clean the
aluminum.
For occasional, more concentrated cleaning eorts, we nd that
Lysol Bathroom Cleaner works extremely well. Many over-the-
counter cleaners will harm the metal nish and cause permanent
damage, even though their direcons indicate safe use on shower
doors. If your unit has AquaGlide coang applied to glass, use only
clean water for daily cleaning. For more concentrated cleaning, use
Basco’s AquaGlide Maintain Spray on the glass and Lysol on the
metal.