Installation Guide

QCI0274 REV. 1 Page 4 Certified 10/01/10
Tools:
To install your Roda Shower Enclosure, you will need the following:
- Pencil
- Low Tack Masking Tape
- Tape Measure
- 4’ & 6’ Levels
- #2 Phillips Screwdriver
- Drill
- 3/16” - 1/4” Drill Bit
- Hack Saw
- Caulk (Clear Silicone Recommended)
- Caulk Gun
- Suction Cups
- Center Punch (if drilling into tile)
- Files
Installation Notes:
This unit is best installed by two people.
Cover the drain with tape prior to installation to prevent loss of small parts.
Unpack your unit carefully and inspect for freight damage. Lay out and identify all parts using the
instruction sheet as a reference. Before discarding the carton, check to see that no small hard-
ware parts have fallen to the bottom of the box. If any parts are damaged or missing, refer to the
description noted in the instructions when contacting your dealer for replacements.
Handle the glass panels carefully and protect the edges. Safety tempered glass is very resistant
to breakage, but the sharp corners of the panels can damage tile and flooring surfaces. Also, the
glass can break if unequal pressure is applied during installation.
Please wear safety glasses whenever drilling or cutting. When drilling holes in ceramic tile or mar-
ble, use a center punch and hammer to carefully break the glazed surface to prevent skidding
when drilling.
Maintenance:
Two primary materials are used to manufacture your new Basco shower enclosure: tempered
glass and anodized aluminum. To assure a long lasting finish on the enclosure, wipe it down with
a towel after each use.
For occasional, more concentrated cleaning efforts, we find that Lysol Non-Abrasive Bathroom
Cleaner works extremely well. Be sure that any over spray falling on the aluminum frame is
rinsed thoroughly and dried. Many over-the-counter cleaners, if applied to the aluminum and left
on, will harm the metal finish and cause permanent damage even though their directions indicate
safe use on shower doors. Never use a scouring agent to clean the aluminum.
NOTE: Tempered glass cannot be cut.