Installation Guide

QCI0274 REV. 1 Page 10 Certified 10/01/10
On the interior face of the glass, place a
strip of low tack tape on the glass about
1/8” to 3/16” away from edge of the u-
channel both vertically and horizontally.
Run a small bead of silicone along this
edge. Next, on the interior, run a bead of
silicone between the u-channel and the
threshold and also between the u-channel
and the wall. After completing, remove the
tape before silicone sets.
NOTE: DO NOT USE the shower until the silicone is completely cured. Check the tube
of silicone for the manufacturer recommended cure time (typically 24 - 48 hours).
*NOTE: Once unit is fully adjusted and gaps between panels are properly set, door
hinges need to be shimmed to prevent door slippage. (see Appendix A)