Installation Guide

QCI0274 REV. 1 Page 9 Certified 10/01/10
Place 1/8” setting blocks as shown or approximately
every 18”. DO NOT place setting blocks over screw
heads.
Using suction cups slide the Fixed Panel Glass into the
appropriate side. Use setting blocks to make exposed
edges of the glass level and plumb. Exposed edges
MUST be level and plumb before moving to next step.
**Different size setting blocks may be required depend-
ing on level conditions. Various size setting blocks are
provided and can be used in different combinations
(stacked) to obtain the desired results.
Place the Drip Vinyl onto the bottom of the door panel.
Line it up on the hinge side of the door and cut it off
flush with the strike edge of the door.
NOTE: The sweep may be pulled up or
down on the glass to adjust how much of
the sweep contacts the threshold
TIP: Run a small bead of silicone between the
drip vinyl and the glass to secure the vinyl
sweep and prevent water from collecting inside
the sweep if adjusted.