Installation Sheet

QCI5298 REV. 0 Page 11 Cered 10/1/17
Remove the jamb from the wall. At each marked location, drill for installation of the jamb. Use
Table 3 to determine hole size and installation method for the strike jamb
12
Align the Wall Jamb [4] along the
centerline marked up the strike side
wall.
Use a level to ensure the wall jamb is plumb.
Mark the hole locations on the wall.
11
Table 3 - Mounting Hole Drilling Requirements
Wall Material
Fiberglass or Acrylic Fiberglass or Acrylic Tile/Other
Reinforced Walls YES NO -
Drill Diameter 1/8" 1/8" 3/16"
Insert Required NO No Yes, Blue Insert
CL
13
Insert a small amount of silicone into each
drilled hole.
If applicable, insert a blue wall plug into
the hole. Carefully cut the head flush with
the wall using a razor blade.
Position the u-channel and secure with #8
Flat Head Screws [14].
Use caution so as to not strip the in-
serts or fiberglass wall material!
Wall hidden
for clarity