Installation Sheet

QCI5298 REV. 0 Page 12 Cered 10/1/17

Using alcohol pads from the Parts Pak, wipe down

the hinge notches and notch gasket areas on the

Door Panel Glass [1]. Allow glass to dry before

continuing.

Remove the back plates from both HG1J Hinges [8].

Place a thick gasket on the Hinge [8] and place the fixed

part of hinge onto the outside of the Door Glass [1].

Next, place another thick gasket against the inside of the

glass and attach the back plate with the screws provided.

The interior of hinges must press firmly against top side

of notch.

Using a screw driver, use 8 hinge mounting screws [12] to attach both HG1J Hinges [8] to

SC982 Adjustable Jamb [3].

Hinge Mounting Screw [12] are self threading screws. The mounting holes, while pre-drilled, are

not tapped by Basco. The screws will go in easily using a standard screw driver. If power tools are

used to insert the screws, use caution so as to not strip the metal.

Loosen the screws from step 8 and adjust as required to achieve a 1/4” gap between the Glass and

Jamb.

Be sure to tighten these screws again.

As viewed from inside of shower