Installation Sheet

QCI5298 REV. 0 Page 14 Cered 10/1/17

While keeping the door level, plumb, and with the correct gap at the strike side; drill 5/32”

holes through the SC982 Wall Jamb [2] at the locations marked by the holes near each hinge

in SC983 Adjustable Jamb [3]. The holes are on the side of the jamb, both inside and out-

side of the shower.

Insert Hinge Jamb Screws [11] into each hole drilled in step 18.

The screws will go in easily using a standard screw driver. If power tools are used to insert the

screws, use caution so as to not strip the metal.

DO NOT open the door until the

both Hinge Jamb Screws [11] are

installed on the inside or outside

of the shower. There is nothing

securing the door to the wall unit

these screws are installed. The

door WILL fall.

Once both screws are installed the

door may be carefully temporarily

opened to allow access to the other

side of the door for installation of the

Hinge Jamb Screws [11].