Installation Sheet
QCI5298 REV. 0 Page 17 Cered 10/1/17
From INSIDE SHOWER drill 2 1/8” diameter holes through the inside wall of the Strike and
Wall Jambs.
Locate the hole 1.5” from the top and bottom edges of the jamb, 3/4” from the wall.
24
Insert screw SCR24 [13] into each hole to secure the strike jamb into position.
3/4”
1 1/2”
CL
To prevent the door from sagging after final
gap adjustment the hinge maybe shimmed
to prevent movement.
Remove one back plate at a time and fill gaps
(marked in the figure to the left) surrounding hinge
with shims supplied in parts pack. Make sure to
shim both hinges and use combination of shim
thicknesses to fill entire gap.
25