Installation Sheet

QCI5298 REV. 0 Page 8 Cered 10/1/17
5
Drill 5/16” diameter holes at each marked location.
Install 1 TOGGLER® per hole following the manufacturers’ installation instructions.
Fold anchor in middle
Insert anchor in hole and tap
flush
At each marked location, drill a 3/16” clearance hole through the
finished wall material only.
Drill a 1/8” diameter pilot hole 1” deep into the blocking at the
marked locations.
IF BLOCKING IS AVAILABLE IN THE WALL
6
IF WALL ANCHORS ARE REQUIRED FOR INSTALLATION
CL
Insert key to pop anchor open in
wall.
Do not hammer key.
Remove key.