Installation Guide

“C” Pull Handle / Towel Bar Combination

Installation Instructions

There are eleven hardware components for the combination pull/towel bar mounting: Six 1 1/4” metal washers,

one towel bar, one “C” pull, two end caps with threaded studs, one stud head screw. In addition to these

hardware parts, there are six clear gaskets that act as a a buffer between the hardware and the glass.

STEP 1 Take the stud head screw and sleeve a 1 1/4” washer on it. Now take both end caps with a

threaded stud protruding and sleeve a 1 1/4” washer on them. Sleeve a clear gasket on each of the screws.

STEP 2 The towel bar will be mounted first. Take the stud head screw with the washer and gasket

attached and, from the inside of the enclosure, push the threaded portion through the top hole in the glass

on the strike side of the door. Place a clear gasket and then a 1 1/4” washer over the stud head screw on

the outside of the glass door. Next, thread the stud head screw into the towel bar and tighten. On the other

end of the towel bar, on the hinge side, push one of the end caps with the protruding threaded stud through

the hole in the glass. Now place a clear disc and then a 1 1/4” washer over the threaded stud on the outside

of the glass door. Thread the end cap into the towel bar and tighten by hand. Tighten both components, the

stud head screw with a screw driver and the end cap using a small allen wrench in the hole in the side of

the end cap.

STEP 3 Place a plastic disc over the end cap and, from the outside of the enclosure, push the end cap

with the protruding threaded stud through the bottom hole in the door glass. Next, thread the stud into the

small threaded opening of the pull handle. Do not fully tighten yet. Place the end of the pull handle with the

large hole and the set screw over the stud head. Now tighten the end cap as tight as possible using a small

allen wrench in the hole in the side of the end cap. Use the larger allen wrench to tighten the set screw, in

the under side of the pull handle, to the stud head screw.

J Interior pull handle (1)

K Towel bar (1)

L Metal washers (6)

M Large clear discs (6)

N Small clear discs (6)

O Glass hole sleeve (3)

P Stud screw (1)

Q Threaded end cap (2)

QCI5028 Rev 1 Page 9 Certified 09/19/2018