Installation Guide
QCI5150 Rev 0 Page 10 Cered 6/6/2016
10 Remove the Anti-Jump from the clamp [8]. Loosen the Clamp screw but DONOT remove it.
Slide the Clamp [8] over the glass panel and the Header [1] with the screw on the inside of the
shower. Set a distance between the exposed glass edge and the Clamp [8] equal to 1/4” then tight-
en the screw.
11 Measure the width of the Door Panel. Place a mark on the threshold measuring the same dis-
tance from the open wall (See illustration). Place the Guide [11] on the door side of the mark and
against inside face of the U-channel. Mark the location of the two mounting holes of the Guide onto
the threshold. Next, drill two 3/16” diameter holes at the marked locations. Insert a small amount of
silicone into each drilled hole and insert a wall plug into each hole. Then, carefully cut heads off of
the wall plugs with a razor blade so there is nothing raised above the surface of the threshold. Place
Guide [11] in correct position and secure it with #8 x 1-1/2” truss head screws [18].