Installation Guide
QCI5150 Rev 0 Page 11 Cered 6/6/2016
12 Take the Roller with Stopper Pin [9] and set the roller
cam shaft by loosening the set screw with the 4mm Allen
wrench and rotate the cam shaft to set the adjustment hole to
horizontal then retighten the set screw.
Do the same steps with the Roller [10].
Remove mount bolts and washers before
mounting the Roller Assemblies [9/10] to the
Door Panel.
Note: The Rollers [9/10] have +/-1/8” height adjustment.
13 Mount the Roller Assembly With Stopper Pin [9] to the wall side of the Door Panel with the
bolts facing to the outside of the shower. Mount the Roller Assembly [10] to the stationary panel
side of the Door Panel with the bolts facing to the outside of the shower.
14 Cut the Drip Vinyl [5] to the appropri-
ate size. It should be equal to the Door
Width minus 1”. Place the Drip Vinyl [5] on-
to the bottom of the door panel. Line it up
on the wall side of the door.