Installation Guide
QCI5150 Rev 0 Page 14 Cered 6/6/2016
18 Install the Pull Handle [13] or Knob [13]
onto the door as shown.
19 Place the Bottom Catch [12] onto the bottom of the Door Panel approximately 1/4” from the
edge of the door. Completely close the door and adjust location of the Bottom Stopper (see illustra-
tions). Mark its location on the glass (a small peace of tape works best). Remove the Bottom Catch
and apply a small amount of silicone to the inner surfaces of the Catch. Place the Catch back onto
the glass at its marked location.
Run a small bead of silicone where the glass and the Bottom Catch meet on the inside of the Door
Panel.
20 Measure the distance between the wall and the Stationary Panel. Then cut the Filler [4] to the
measured distance. Run a small bead of silicone along both sides of the Filler [4].
Then insert the filler into the U-channel [2] (see illustrations).