Installation Guide
QCI5150 Rev 0 Page 8 Cered 6/6/2016
7 Disassemble two Wall Mount Header Brackets
[7] by loosening the set screws. Screw the inner
part of the Header Bracket [7] into the wall with
the supplied socket countersunk head screw.
8 Check the size of the Header [1]. It should be equal to the
opening size minus 1 1/2”(+/- 1/8” tolerance). Slide the Wall
Mount Header Brackets [7] on both ends of the Header [1], align
the Header with the inner part of the Header Brackets [7]
mounted to the walls and slide out the Wall Mount Header
Brackets [7] (see pictures). Rotate the Wall Mount Header
Brackets, the set screws should be facing up and inside the
shower .Then tighten the 4 set screws on each Wall Mount
Header Bracket.
Note: The set screws closest to the wall must be tightened
REMOVE AND DISCARD THE
INCLUDED WALL PLUG