Installation Guide
QCI5150 Rev 0 Page 9 Cered 6/6/2016
9 Place 1/8” setting blocks [20] into the U-channel as shown or approximately every 18”.
DO NOT place setting blocks over screw heads, but set them close to ensure that the screw heads
are below the setting blocks.
Using suction cups set, the Stationary Glass Panel into the U-channels on the appropriate side. Use
different sizes of setting blocks to make exposed edges of the glass level and plumb.**
Exposed edges MUST be level and plumb before moving to next step.
**Different sizes setting blocks may be required depending on level conditions. Various sizes of set-
ting blocks are provided and can be used in different combinations (stacked) to obtain the desired
result.