Installation Guide
QCI5301 Rev 1 Page 20 Cered 6/5/2017
23 Install the rollers on the outer panel. The rollers will be on the inside of the shower.
-The rollers are mounted to adjustable cams. Install them with the rollers at the lowest position.
-Temporarily install the anti-jumps parallel to the floor.
-Only snug the screws for now.
NOTE: There are small part numbers on each part of the roller. All of them will face the glass.
22 Un-tape the Hold Downs and slide them to clamp down
on the Track tightly. Then insert and tighten the SCR30 Screw
into the Hold Down.
The Screw will push against the Wall Jamb and keep the Hold
Down in place.
If using 3/8” glass connue to step 24A, if using 1/4” glass connue to 24B