Installation Guide

  
9 After marking, remove header assembly [8]. Drill a 1/4” diameter hole approximately 1 3/4”
deep, at the marked wall location.
10 Reassemble the roller bar header assembly [8] by securing the header assembly to the
wall mount header bracket and then tightening down the set screws.
NOTE: Flat side of wall mount header bracket should face towards the door.
Do not over-tighten screws.
Next, put the supplied large wall plugs into the hole. Screw the inner part of the
Header Bracket into the wall with the supplied socket countersunk head screw.





After the header assembly is secure,
install the door stopper [13] onto the
header assembly [8] by screwing in top
mounting screw. (See Example)
COMPLETED HEADER ASSEMBLY



1. 2.