Installation Guide

QCI0286 6 XX/XX/XXXX

4 Verify that the U-channel [3] is cut

properly using the below formulas:

U-channel Height = Unit Height - 3/4”

U-channel Height = Panel Glass Height - 9/16“

Note: If out of level conditions exist be sure

to use the longer U-channel on the appropri-

ate side (see illustration).

Next, drill three 3/16” diameter holes in the

center of U-channel (centerline groove

provided for convenience); one hole 2-1/2”

from each end and one hole in the middle.

Place the U-channel over the wall centerline

marked in step one. With a pencil, carefully

mark each hole position on the wall centerline.

Drill a 3/16” diameter hole, approximately 1”

deep, directly on the wall centerline at the

marked locations.

3 Insert a small amount of silicon into each drilled hole, then insert a wall anchor into each hole.

(Note: Drill hole, then insert a wall anchor.) This must be done just before u-channel installation.

Carefully cut the heads off the wall anchors with a razor blade. Place the U-Channel in correct posi-

tion and secure it with #8 x 1-1/2” truss head screws.