Installation Guide
QCI0286 7 XX/XX/XXXX
5 Insert a wall plug [16] into each drilled hole. Then
carefully cut the heads o of the wall plugs [16] with a
razor blade. So there is nothing raised above the sur-
face of the wall.
Place the u-channel [3] in posion and secure
it with #8 x 1-1/2” truss head screws [18].
6 Place 1/8” setting blocks [20] into the U-
channel as shown or approximately every 18”.
DO NOT place setting blocks over screw heads,
but set them close to ensure that the screw heads
are below the setting blocks.
Note: Do not over-ghten the screws.
Using suction cups set, the Stationary
Glass Panel into the U-channels on the
appropriate side. Use different sizes of
setting blocks to make exposed edges
of the glass level and plumb.**
Exposed edges MUST be level and plumb
before moving to next step.
**Different sizes setting blocks may be
required depending on level conditions.
Various sizes of setting blocks are provided
and can be used in different combinations
(stacked) to obtain the desired result.