User Manual

ManualsBrandsBaseline Systems ManualsSensorsBaseStation 3200 in X/XS Cabinet

BL-3200WF-X Wi-Fi Module for X/XS Cabinet

Installation Guide

1-866-294-5847 Rev 9.30.2014 www.baselinesystems.com

Required Tools

 Phillips screwdriver

 Needle-nose pliers

 Crescent wrench

Installing the Wi-Fi Module

1. Remove all parts from the packaging.

2. Power down the controller.

3. Loosen the two screws on the top of the control

board cover.

4. Carefully remove the cover and set it aside.

5. Use needle-nose pliers to remove the rubber

plug from the antenna port on the top of the

cabinet.

6. Remove the nut and the lock washer from the

bottom of the antenna, and then insert the stem

of the antenna into the port on the top of the

cabinet.

7. From the inside of the cabinet, place the lock

washer on the stem of the antenna, and then

thread the nut onto the stem. Use a wrench to

tighten the nut sufficiently to ensure that the

antenna makes good contact with the outside

of the cabinet.

8. Partially thread one of the provided mounting

screws into the lower mounting pin (C) on the

inner top of the cabinet.

9. Connect the end of the antenna cable onto the

stem of the Wi-Fi module and hand-tighten it.

10. Position the notch on the edge of the Wi-Fi

module mounting plate on the partially

threaded screw (C). Tighten the screw so it holds

the mounting plate in place.

11. Align the holes on the Wi-Fi module mounting

plate with the mounting pins (A & B). Use the

screws provided to securely attach the module

inside the cabinet.

Connued 

Page 1

Summary of content (4 pages)

PAGE 1
BL-3200WF-X Wi-Fi Module for X/XS Cabinet Installation Guide Required Tools  Phillips screwdriver  Needle-nose pliers  Crescent wrench Installing the Wi-Fi Module 1. Remove all parts from the packaging. 2. Power down the controller. 3. Loosen the two screws on the top of the control board cover. 4. Carefully remove the cover and set it aside. 5. Use needle-nose pliers to remove the rubber plug from the antenna port on the top of the cabinet. 6.
PAGE 2
BL-3200WF-X Wi-Fi Module for X/XS Cabinet Installation Guide 12. Carefully turn the Wi-Fi module in the mounting bracket so the indicator lights are visible. 13. Inspect the cable coming from the right end of the Wi-Fi module. A label identifies the RJ45 connector that is plugged into the Wi-Fi module. If you ever need to disconnect or replace this cable, make sure to plug the labeled end into the Wi-Fi module.
PAGE 3
BL-3200WF-X Wi-Fi Module for X/XS Cabinet Installation Guide 17. Gently gather the antenna cable into two loops, and then connect the end of the antenna cable onto the stem of the antenna and hand-tighten it. IMPORTANT! Do not bend or kink the antenna cable. 18. Keep the antenna cable looped, and then reposition the control board cover so it covers the antenna cable and holds it in place. 19. Tighten the screws on the control board cover. 20.
PAGE 4
BL-3200WF-X Wi-Fi Module for X/XS Cabinet Installation Guide Troubleshooting Tips If the Wi-Fi module is not performing as expected, you might need to try the following troubleshooting steps.  Make sure the antenna cable is not bent or kinked in any way. You might need to remove the control board cover to see the antenna cable.  Make sure the RJ45 connector is properly seated in the end of the Wi-Fi module.