User manual
21
• Charging begins. The display will show various information on the current
charging progress.
Example:
At the upper left, the rechargeable battery type and the cell number are displayed ("Li3S" = Lithium rechargeable
battery with 3 cells); the charging current is shown in the upper middle and the current rechargeable battery voltage
at the upper right.
The lower left shows the current rechargeable battery programme ("CHG" = "CHARGE"), in the middle the elapsed
charging time and the charged capacity in mAh are displayed to the right of this.
Various information is indicated on the display during a charge/discharge process by repeatedly pressing
the button "–" (see chapter 20). If you do not push any button for a few seconds, the charger will return to
the normal display.
• After completion of charging, an audio signal is emitted (if it has not been turned off).
If you wish to cancel the charging process prematurely, push the button "STOP".
c) Charging Rechargeable Batteries with Balancer Connection ("BAL-CHG")
In contrast to the simple rechargeable battery programme "CHARGE" (see
chapter 11. b), the rechargeable battery programme "BAL-CHG" monitors the
voltage of every single cell of a multiple-cell lithium rechargeable battery and
corrects it accordingly if there are any deviations.
Besides the two normal rechargeable battery connections (plus/+ and minus/-), the balancer connector for the battery
must also be connected to the charger.
The balancer connection of the rechargeable battery must be connected to the charger via the enclosed balancer
board (with XH connections). If your rechargeable battery has a different balancer plug, you need a suitable adapter
cable (not enclosed, can be ordered separately).
If you use self-customised rechargeable batteries, the balancer plug must be correctly assigned.
The black cable is the minus pole of the rst cell. The next connection pin is the plus pole of the rst cell;
the respective next connection pin is the plus pole of the second, third, fourth, fth and sixth cell (depending
on cell number).
The last connection pin of the balancer plug of the rechargeable battery therefore is the plus pole of the last
cell. Therefore, the same voltage can be measured between the two outer pins of the balancer plug as at
the two rechargeable battery connections directly.
The remaining procedure for charging is described in chapter 11. b).
If a lithium rechargeable battery with balancer plug is connected
to the charger, you can switch to the display of the individual cell
voltages by pushing the button "+", see gure on the right.
For 5- or 6-cell rechargeable batteries, push the button "+" again to switch between the displays of cells
1/2/3/4 and 5/6.
Briey push the "+" button or the "START" button so that the charger will return to the normal display (you can also
wait for a few seconds without pushing any button).
.
Li3S 1.2A 12.3V
CHG 022:43 00682
LiPo BAL-CHG 3S
C= 3000mAh 3.0A
C1:3.83 C2:3.78
C3:3.80 C4:3.81