User manual

• If the values need to be changed, push the "START" button. The discharging end voltage per cell ashes. Set this

voltage with the button "+" or "–". Keep the respective button pressed for quick adjustment.

The discharge end voltage set here applies per cell. The total voltage of the connected rechargeable bat-

tery is automatically calculated after setting the cell number (see below) and displayed at the lower right of

the display.

Conrm the discharging end voltage by pressing the "START" button.

• The discharge current at the lower left of the display ashes. Change the discharging current using the button "+"

or "–". Keep the respective button pressed for quick adjustment.

The maximum possible discharging current depends on the battery type and number of cells. The max.

discharge output of the charger is 5 W and thus limits the discharging current.

Conrm the discharging current with the "START" button.

• The number of the cells in the lower right of the display ashes. Set the number of the cells with the button "+" or

"–". Keep the respective button pressed for quick adjustment.

Depending on the cell number and the discharge end voltage set per cell (see above), the total voltage of

the connected rechargeable battery is calculated automatically (at the end of the discharge process) (for a

two-cell Lithium rechargeable battery, e.g., 6.0 V).

Conrm the cell number with the "START" button; the display stops ashing.

• When no display is ashing anymore, keep the "START" button pushed (approx. 3 seconds), to start discharging.

• After starting the discharging process, various information about the current

progress is shown in the display.

In the upper left, the rechargeable battery type and the cell number are dis-

played ("Li3S" = Lithium rechargeable battery with 3 cells); the discharging

current is shown in the upper middle and the current rechargeable battery

voltage in the upper right.

The lower left shows the current rechargeable battery programme ("DSC" = discharging rechargeable battery), the

middle the elapsed discharging time and the discharged capacity is mAh is displayed to the right of this.

A multiple-cell rechargeable battery must be connected to the

charger with the balancer connection as well when discharging.

Here, you can switch between the normal display and the display of

the cell voltage while discharging by pushing the "+" button several

times.

For 5- or 6-cell rechargeable batteries, push the button "+" again to switch between the displays of cells

1/2/3/4 and 5/6.

• After completion of discharging, an audio signal is emitted (if it has not been turned off).

If you wish to cancel the discharging process prematurely, push the button "STOP".

Li3S 1.0A 12.3V

DSC 012:43 00252

C1:3.83 C2:3.78

C3:3.80 C4:3.81