User manual
28
• When no display is ashing anymore, keep the "START" button pushed (approx. 3 seconds), to start discharging.
• The charger now examines the connected rechargeable battery. In case
of an error, a warning signal is output and the corresponding information is
displayed. You can stop the warning signal by pressing the "STOP" button.
You then return to the previous conguration menu.
If no error is found, e.g. the display shown on the right will appear.
The rechargeable battery type is displayed in the upper left of the display,
the upper middle shows the discharging current and the upper right the cur-
rent rechargeable battery voltage.
The lower left shows the current rechargeable battery programme, in the middle the elapsed charging time and the
charged capacity in mAh are displayed to the right of this.
• After completion of discharging, an audio signal is emitted (if it has not been turned off).
If you wish to cancel the discharging process prematurely, push the button "STOP".
e) Cycle Programme ("CYCLE")
To test rechargeable batteries, form new rechargeable batteries or refresh older rechargeable batteries, you can
perform up to 5 cycles in sequence automatically. The two possible combinations are "Charge/Discharge" and "Dis-
charge/Charge".
Proceed as follows:
• Set the rechargeable battery type as described in chapter 12. a) (NiMH or
NiCd) and select the rechargeable battery programme "CYCLE".
The set rechargeable battery type is shown in the upper left of the display,
and the rechargeable battery programme in the middle.
The display at the upper right represents the corresponding combination "Charge/discharge" ("C>D") or "Discharge/
charge" ("D>C"). The charge current ("C") is shown in the lower left, the discharge current ("D") in the middle and
the number of currently set cycles in the lower right.
Use the buttons "+" or "–" to select a different rechargeable battery programme; use the button "STOP" to
return to the main menu.
• Push "START" to change the settings. The order for the cycle programme ("C>D" or "D>C") ashes.
• Use the buttons "+" or "–" to select the desired order ("C>D" = Charge + subsequent discharging; "D>C" = Dis-
charge + subsequent charging).
• Briey push the "START" button; the charging current ashes. Change the charging current using the buttons "+" or
"–". Keep the respective button pressed for quick adjustment.
• Briey push the "START" button; the discharging current ashes. Change the discharging current using the buttons
"+" or "–". Keep the respective button pressed for quick adjustment.
• Briey push the button "START"; the number of cycles ashes (how often the currently set sequence of charging/
discharging or discharging/charging is performed).
NiMH 2.0A 7.4V
DSC 022:45 00690
BATTERY CHECK
PLEASE WAIT...
NIMH CYCLE C>D
C=1.0A D=1.0A 1