User manual
29
• Set the cycle number with the buttons "+" and "–" (1 - 5 cycles are possible). Push the "START" button briey then
to conrm the setting. The display stops ashing.
• To start cycle programme, keep the "START" button pressed for longer (approx. 3 seconds).
• The charger now examines the connected rechargeable battery. In case
of an error, a warning signal is output and the corresponding information is
displayed. You can stop the warning signal by pressing the "STOP" button.
You then return to the previous conguration menu.
If no error is found, e.g. the display shown on the right will appear.
The rechargeable battery type is shown in the upper left, the upper middle
shows the charging or discharging current and the upper right the current
rechargeable battery voltage.
The lower left shows the selected cycle programme ("C>D" = Charge/discharge, "D>C" = Discharge/charge), the
middle shows the elapsed charging or discharging duration and the right next to it the charged or discharged
capacity in mAh.
• After completion of the cycle programme, an audio signal is emitted (if it has not been turned off).
To interrupt the cycle programme prematurely, push the button "STOP".
NiMH 2.0A 7.42V
C>D 022:45 00890
BATTERY CHECK
PLEASE WAIT...