User manual
5
3. Intended Use
The charger is used to charge and discharge rechargeable batteries of the type NiMH/NiCd (1 - 15 cells), LiPo/LiIon/
LiFe/LiHv (1 - 6 cells) and lead batteries (1 - 10 cells, 2 V - 20 V).
The charge current can be set between 0.1 A and 10.0 A (depending on the cell number/ rechargeable battery volt-
age). The maximum charging power is 80 W.
The discharge current can be set between 0.1 A and 2.0 A (depending on the cell number/ rechargeable battery volt-
age). The maximum discharging power is 5 W.
The charger is operated by four operating buttons and a two-line lit LC display.
The charger also offers a connection for an external temperature sensor (not enclosed, available as an accessory)
for rechargeable battery monitoring. A balancer is integrated for multiple-cell lithium batteries. For connection of the
rechargeable battery, a matching external XH adapter for rechargeable batteries with 2 - 6 cells is enclosed.
The charger has an integrated mains unit to permit operation on mains voltage (100 - 240 V/AC, 50/60 Hz). The
charger may, however, also be alternatively operated on a stabilised direct voltage of 11 - 18 V/DC (e.g. via an external
vehicle lead battery or a suitable mains adapter).
The safety notes and all other information in these operating instructions always have to be observed!
Read the operating instructions carefully and attentively, and keep them for later reference. Only pass the product on
to any third parties together with the operating instructions.
Use other than that described above can lead to damage to the product and may involve additional risks such as, for
example, short circuits, re, electrical shock etc. The entire product must not be modied or converted, and the casing
must not be opened!
This product complies with the statutory national and European requirements.
4. Scope of Delivery
• Multifunctional charger
• Mains cable
• XH adapter
• Connection cable with alligator clamps
• Operating instructions (on CD)
Current operating instructions
Download the current operating instructions via the link www.conrad.com/downloads or scan the
QR code displayed. Observe the instructions on the website.