Instructions

b) Installation
In order to install the sensors, you need a drill in order to drill the necessary holes into the
bumper.
Prior to drilling, carefully mark the position of the holes.
Make sure that the sensor angle is not obstructed by vehicle parts. This would lead to
malfunctioning.
The ultrasound sensors must be installed evenly across the width of the vehicle.
The distance between the sensors may not exceed 30 to 40 cm.
The installation height should be in a range from 50 to 80 cm.
1Drilling fastening holes
Observe the safety notices when drilling. Make sure that you do not damage any lines
or cables in the drilling area.
22