Instructions

4Installing the display

The core of the parking aid is the acoustic or optic display with integrated warning buzzer.

The displays are attached on the installed adhesive pad. For this purpose, pull the protective

paper off the pad.

When selecting the installation site, make sure that the display is not in the direct

visibility range of the driver or in safety-relevant areas (airbags, etc.).

The surface to which it is attached must be absolutely clean and grease-free. Do not

attachthepadbelow5°C,otherwisethepadwillnotstickproperly.

c) Connection

After installation of all components, you have to connect the display cables and the voltage

supply.

Connectallcablesasdepictedintheconnectionschemein“Individualpartnames”.Theplugs

onlytinthesocketwiththecorrectpolarity.

• Connecttheplugoftheconnectioncables(3or4)withthesocket“DISP”onthecontrol

unit (1).

• Connectthefourplugsoftheultrasoundsensors(AtoD)intherightsequencewiththe

sockets“A,B,C,D”ofthecontrolunit(1). Make sure that the letters on the cables and sockets

are in the right sequence.

After you have made almost all connections, you have to connect the voltage supply.

As the parking aid only works when the reverse gear is shifted, it is supplied by the taillights.

Measure the correct cable with a voltmeter or a diode test lamp when the reverse gear is set

and the ignition is on. The lights and the blinkers should be off. If you were able to determine the

right cable, turn the ignition off again.

Connecttheredpluscable(5) with the voltage supply cable of the headlight. Make sure that the

contact place is permanently insulated (e.g. insulated clamps, tape, etc.).

With an optional cable cutting connector, you can easily establish safe contact without

severing the light cable.

For this purpose, place the cable cutting connector around the voltage cable of the

headlight and additionally the red conductor of the connection cable (5) into the

connector. Use pliers to press the contact point onto the cables.