User's Manual

This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC RF exposure statement:
The equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance between 20cm the radiator your body.
7、Operation description
The power button operation instructions
For viewing electric quantity:
Press the button once to initiate the power output function, when you can view the
remaining electric level of the power bank. After lit for 30sec, the LED indicator will
extinguish automatically.
Operation for discharging by cable:
Connect the USB charging cable to the corresponding output port of the power supply, and
the power supply will automatically turn on the output. Due to compatibility problems,
some smart phones need to press the key to turn on the power output function, which is a
normal phenomenon and need not be ignored. Press the key once to supply power to the
external equipment. Press the key once to output power for about 30 seconds. If there is no
external load in 30 seconds, the power output will be automatically turned off.