User's Manual

7
Cleaning the filter element filter (Figure 36)
Regularly remove the filter from the top cover of the dirty water tank, rinse the attached dirt with clean
water, and place it at the vent to keep the filter dry and clean.
Cleaning the roller brush (Figure 37)
Regularly take out the roller brush, use the provided roller brush cleaning tool to remove hair or debris
entangled in the brush, rinse the roller brush with clean water, and regularly place it in the vent to keep
the roller brush dry and clean. Cleaning the roller brush cover and pipe: Use the provided cleaning tool
to clean up the dirt left on the roller brush cover or pipe, and keep the air duct and water passage
unobstructed.
Cleaning the charging base (Figure 38)
Regularly clean the charging base. Do not let the charging port get wet. Use it when dry.
Servicing the battery (Figure 39)
The product should be fully charged at least once every 3 months to keep the battery in a healthy state.
Storing the product (Figure 40)
Clean the clean water tank, dirty water tank and roller brush, and store them separately after drying.
The storage location should be kept dry, ventilated and protected from sunlight.
Troubleshooting
Common Issue
Possible Cause
Solution
The product does not work.
The dirty water in the dirty
water tank reaches the specified
level.
Clean the dirty water tank.
The roller brush is entangled
with debris.
Clean the roller brush.
The roller brush is not installed.
Install the roller brush according
to this manual.
The product cannot be charged.
The main unit is in poor contact
with the charging base.
Check the socket of the charging
base used to install the main
unit.
The water is not dispensed when
the roller brush is in water
dispensing state.
The clean water tank does not
have sufficient water or is not
properly installed.
Add water to the clean water
tank or reinstall the clean water
tank.
Water in the air outlet.
The filter is not installed in the
dirty water tank.
Check filter. Maintain and clean
the dirty water tank according to
this manual.
The filter is not dry.
Reinstall it according to the
instructed instructions in this
manual.
The dirty water tank is not full.
The filter/Hepa filter is clogged.
Clean the dirt attached to the
filter/Hepa filter.
The product prompts that the
water is full.
The Hepa filter is too wet.
Dry the Hepa filter before use.
The X3 jitters.
The roller brush is not properly
installed.
Reinstall the roller brush.
Water leakage during mopping,
insufficient suction for wet
spots.
The filter element is too wet.
Clean and dry the filter element.