Data Sheet

Page 2 of 4
www.innofil3d.com | [e-mail] | PO Box 1146 | 7801BC Emmen the Netherlands
MECHANICAL PROPERTIES
Test Method ISO 527
All test specimens were printed
using an Ultimaker 2 under the
following conditions: printing
temperature = 210°C, heated bed
temperature = 75°C, print speed =
40 mm/s, number of shells = 2,
Infill under 45°
Printed vertical (Z-axis)
Printed horizontal (X,Y-axis)
Infill
50%
100%
50%
100%
Tensile strength (MPa)
14.68 ± 3.29
28.84 ± 4.20
24.12 ± 0.58
38.08 ± 0.89
Force at break (MPa)
14.45 ± 3.19
28.64 ± 4.07
23.86 ± 0.63
36.28 ± 1.14
Elongation at max force (%)
0.85 ± 0.32
1.10 ± 0.23
2.16 ± 0,07
2.10 ± 0,00
Elongation at break (%)
0.85 ± 0.32
1.10 ± 0.23
2.40 ± 0.12
2.84 ± 0.19
Relative tensile strength
(MPa/g)
1.59 ± 0,40
2.35 ± 0,36
2.72 ± 0,06
3.25 ± 0,08
Emodulus (MPa)
2027 ± 44
3150 ± 54
1760 ± 38
2852 ± 88
STRESS – STRAIN CURVES
Vertical 100%
Horizontal 100%
Tensile strength (MPa)
Tensile strength (MPa)
Elongation (%)
Elongation (%)