User`s manual

V 1 P R O F E S S I O N A L 5 . 7

Click the

Reset

button to instantly un-select all tabs and return to the single-tab move

mode. Click the

Review

button the display a slideshow of all selected tabs. As with a

single tab, to proceed with the move of multiple tabs, click the

Move

button on this

window. To close the window without moving, click

Cancel

When tabs are moved to or from your system’s hard drive and a removable disk (such

as a re-writable CD or floppy disk), the original tab is not removed. Instead, a copy is

made. In the case of a multiple tab move where the destination bin runs out of space,

an error message will be displayed, and the yet un-moved tabs will remain selected.

This allows you the opportunity to insert an additional removable disk to continue the

move operation on the remaining tabs.

Trim

The

Trim

function allows you to shorten a video to conserve hard drive

space, or to make a full or partial copy of a video into a new tab on your

system’s hard drive. Open a video, and then click the

Trim

button to show

this window:

The Trim Tab window shows the original and the new file duration (in seconds). You

will notice that on the video position slider there are vertical blue and red lines. These

represent the new beginning and the new ending video positions respectively.

To reset either the beginning or the ending position, first move the video position

using the slider or any of the other Digital VCR controls. Then click either the

New

Start

or the

New End

button as appropriate. You are free to reset either of these

positions as many times as is required. In the sample shown above, video before the

address and after the follow-through positions is ready to be trimmed off, reducing the

size of the video from 2.93 seconds to 1.97 seconds.