User`s manual

V 1 P R O F E S S I O N A L 5 . 7
56
Measure
When you draw a line with the Measure button turned on, the V1 will place
a digital measurement along the line. By default, the units of this
measurement are 100 “pixels” on the display (the V1’s video window is 640
pixels wide and 466 pixels high, so a horizontal line drawn from the leftmost point to
the rightmost point on the window will measure 6.40). You may “calibrate” these
measurements by holding down the Measure button.
The Calibrate window instructs you to “draw a line of known length” and then set a
control to match this value. As soon as you make a change, you will see all on-screen
measurements immediately updated.
NOTE: The Measure button only appears in place of the Animations button if the
golf ball flight animation videos were not installed.
Tempo
When the Tempo button is turned on, a digital readout will appear in the
upper-right corner of the video.
The number displayed here represents the time (in minutes, seconds, and hundredths
of a second) elapsed since the first key position (“address” in golf). Therefore, in order
for the tempo feature to operate effectively, you should accurately set the first key
position for your videos.
You will see negative numbers here if your video includes motion before the first key
position.