User`s manual

Image Acquisition Control AW00098504000
112 Basler ace Camera Link
7.6.4 Frame Cycle Signal
The camera can provide a "Frame Cycle" (FrmCyc) output signal. The signal goes high when the
camera enters a waiting for frame trigger condition and goes low when the exposure time for the
next triggered image ends as shown in Figure 33. (In this example, the camera is operating in the
timed exposure mode.)
The intention of this signal is to let you monitor these two important points in the acquisition process
with a single output signal.
Fig. 33: Frame Cycle Signal
Frame Acquisition N
Exposure
Readout
Time
Frame
Cycle
Signal
Frame Acquisition N+1
Exposure
Readout
Frame Acquisition N+2
Exposure
Readout
ExFSTrig
Signal
= Camera is in a "waiting for
frame start trigger" status