User`s manual

Physical Interface AW00098504000
40 Basler ace Camera Link
5.7.3 Selecting the Input as the Source Signal for a
Camera Function
When the GPIO line is set to operate as an input, you can select the input to act as the source signal
for the following camera functions:
 the acquisition start trigger
 the frame start trigger
Note that when the input has been selected as the source signal for a camera function, you must
apply an electrical signal to the input that is appropriately timed for the function.
For more information about using the input line as the source signal for a camera function, see
Section 6.1.3 on page 50.