User Manual X3 Series (X3, X3 Pro & X3R) X3 X3 Pro X3R
ATTENTION: PLEASE FOLLOW ALL ASSEMBLY INSTRUCTIONS AND READ AND UNDERSTAND THE OPERATING INSTRUCTIONS BEFORE YOU OPERATE THE CADDY, EITHER MANUALLY OR BY REMOTE CONTROL. TABLE OF CONTENTS Page Packing List …………..…………………………………………………..……………………………………………2 1. Standard Parts (X3 & X3-Pro)………………………………………………………………………...2 2. Standard Parts (X3R)……………………………………………………………………………………...2 3. Optional Accessories………………………………………………………………………………………2 Parts Glossary………………………………………………………….………………………………………………3 1.
PACKING LIST 1. Standard Parts (X3 & X3 Pro) 1 Caddy Frame 2 Rear Wheels (Left & Right) 1 Battery Pack (Lead Acid or Lithium Battery, Bag, Leads) 1 Charger 1 Tool Kit 1 User Manual, Warranty, Terms & Conditions 2. Standard Parts (X3R) 1 Caddy Frame 1 Anti-Tip Wheel & Pin 2 Rear Wheels 1 Battery Pack (Lead Acid or Lithium Battery, Bag, Leads) 1 Charger 1 Tool Kit 1 Remote Control (needs 2 AAA Batteries) 1 User Manual, Warranty, Terms & Conditions 3.
PARTS GLOSSARY 1. X3 & X3 Pro 1. 2. 3. 4. T-Handle with Control Face Faceplate and Manual Speed Control Upper Bag Support Upper Bag Support Bungee Pigtails Battery with Leads and Carrying Case (12V Sealed Lead Acid or Lithium Deep Cycle) 5. Rear Wheels (Left & Right) 6. Wheel Hub with Locking Mechanism 7. Rear Wheel Rubber Tread 8. Battery Tray with Plug Receptacle 9. Lower Bag Support and Fender with Support Strap and Tracking Adjustment Mechanism 10. Front Wheel 11.
2. X3R 1. 2. 3. 4. T-Handle with Control Face Faceplate and Manual Speed Control Upper Bag Support Upper Bag Support Bungee Pigtails Battery with Leads and Carrying Case a) (12V 34/35Ah Sealed Lead Acid Deep Cycle) 5. 2 Identical Rear Wheels 6. Wheel Hub with Locking Mechanism 7. Rear Wheel Rubber Tread 8. Battery Tray with Plug Receptacle 9. Lower Bag Support and Fender with Support Strap and Tracking Adjustment Mechanism 10. Front Wheel 11. Frame Locking Hinge 12. 110-240V Charger 13.
ASSEMBLY INSTRUCTIONS 1. X3/X3 Pro 1. Unpack all items carefully and check inventory. 2. Place frame structure (one piece) on soft and clean ground to protect frame from being scratched. Erect frame by unfolding and connecting the main frame tube together at the joint and locking the Y-shape lower support structure to the main frame with the frame lock mechanism. a.
X3 Pro 3. Attach wheels to axles by pushing wheel locking button on the wheel hub and inserting the axle extension into the wheel. Make sure to keep the locking button on wheel hub pushed in during this process, in order to enable the axle extensions to be inserted all the way into the wheel so the axle sprocket locks into the hub. If not locked in, the wheel will not be connected to the clutch and will not be propelled or come off! Test the lock by trying to pull the wheel out.
4. Place battery pack on battery tray and fasten Velcro strap around battery tightly. Insert 3 prong battery plug into caddy outlet so notch aligns properly with plug. It is recommended NOT to fasten the screw on the plug to the outlet, so in case of tip over the cable can unplug from the socket. Note: Before connecting make sure that Rheostat Speed Control on handle is in OFF position! 5.
2. X3R 1. Unpack all items carefully and check parts inventory. 2. Place frame structure (one piece) on soft and clean ground to protect frame from being scratched. Attach wheels to axles by pushing wheel locking button on the wheel hub and inserting the axle extension into the wheel. Make sure to keep the locking button on the wheel hub pushed in during this process, in order to enable the axle extensions to be inserted all the way into the wheel.
6. Place the battery pack on the battery tray and fasten the Velcro strap around the battery tightly. Insert the 3-prong battery plug into the caddy outlet so the notch aligns properly. It is recommended NOT to fasten the screw on the plug to the outlet, so in case of tip over the cable can unplug from the socket. Note: Before connecting, make sure that the Rheostat Controller is in OFF (0) position, and the remote control is stored securely! 4.
OPERATING INSTRUCTIONS 1. X3, X3 Pro & X3R Handle Controls Display screen Speed Control 1. Timed Distance Advance Function : Press once, display will show A , the caddy will run ca. 10 Yards/Meters and stop Press twice, display will show B , the caddy will run ca. 20 Yards/Meters and stop Press three times, display will show C , the caddy will run ca. 30 Yards/Meters and stop ATTENTION: do not use these functions when the caddy is close to water or other hazards! 2.
4. USB plug (optional) located under handle cover for GPS or cell phone. Additional Functions Tracking Adjustment; tracking behavior of all electric caddies is strongly dependent on equal weight distribution on the caddy and slope/topography of the golf course. Test your caddy’s tracking behavior by operating it on an even surface without the bag. If changes are necessary, you can adjust the tracking of your caddy by loosening the front wheel axle and shifting the front wheel as needed.
Installation of Seat Attach seat holding bar to caddy frame Attach seat stand to seat bottom using the four small screws. Attention: Attach in such manner that the seat is parallel to the driving direction of the caddy, with the opening facing the outside when you slide it into the holding bar. Slide seat stand into holding bar as shown. Due to the spring mechanism, the seat should reach the ground when pushed down, so the weight rests solely on the ground.
Remote Control Instructions (X3R Only) Functions: A. Brake: The red STOP button in the middle of the directional arrows should be used for stopping the caddy. B. Timer: 10, 20, 30 yards/meters C. Backward Arrow: Pressing the back arrow will set the caddy in backward motion. Increase backward speed by pushing multiple times. Press also to decrease forward speed/slow down the caddy D. Forward Arrow: Pushing the forward arrow will set the caddy in forward motion. Pushing multiple times will increase the speed.
MAINTENANCE & ADDITIONAL INSTRUCTIONS 1. Battery Charging and Maintenance (see specific separate instructions for sealed lead acid (SLA) and lithium batteries) - - - PLEASE OBEY THESE PRECAUTIONS FOR BATTERY USE & CHARGING: Please do not charge the battery in a sealed container or in upside down position. It is recommended to charge the battery in a well ventilated area. Please do not charge the battery near a heater, where heat accumulation may occur, or in direct sunshine.
- be below its optimal power. Always keep your battery fully charged before another game Never keep your battery connected to the grid during prolonged power outages. It might be irreversibly damaged. Do not fully discharge the battery by “overplaying” it. It is recommended to recharge the battery after every 18 holes.
in remote operation. An additional safety feature of this caddy is that it will stop moving if it does not receive a signal from the remote control at least every 45 seconds. This way, should you ever be distracted, your caddy does not completely get away. By pressing the lower Timer button on the remote the caddy can be moved forward automatically by 10, 20, or 30 yards. STOP will make the caddy stop in case of overreach. Do not use this function close to water or other hazards. 3.
4. General Maintenance The steps below will ensure that you get a prolonged and reliable life out of your Bat-Caddy. - The Caddy has been designed so that the user can concentrate on playing golf, while the caddy does the work of carrying your bag. In order to keep your Bat-Caddy looking its best, we advise that you wipe any mud or grass from the frame, wheels and chassis after every round with a damp cloth or paper towel.
- Microprocessor Controlled Electronics System: When you connect the battery, the electronics system will automatically run through a start-up routine. Then you can press the main OFF/ON switch on the handle. The battery charge indicator lights will show you the charge level of the battery from green (fully charged) to red (discharged). - Important: The electronics controller box contains no user serviceable parts.
TECHNICAL SPECIFICATIONS 1. X3 & X3 Pro Model Name X3 Standard Battery 33Ah SLA Dimensions SLA: 8 x 5 x 6 in (20 x 13 x 15 cm) Weight: 20 Lbs Average charge time: 4-8 hours Lifetime: ca. 150 charges Standard Battery Duration 27-36 holes 35Ah SLA @ $25.00 Battery Upgrade Options 20Ah Lithium @ $400.00 Folded Dimensions Length: 34” (86 cm) Width: 20-21” (51 cm) Height: 16-17” (41 cm) Unfolded Dimensions Length: 46/48” (117 cm) Width: 20/21.5” (51 cm) Height: 39” (99 cm) Weight Caddy 18.7/20.
Rear Wheels Airless, rubberized tread Quick-release mechanism Drive Train Rear Wheel Drive Gear ratio (17:1) Handle Height Adjustment N/A Materials Aluminum/SS and ABS Available Colors Iridium Silver, Black, White Complimentary Accessories Scorecard Holder (depending on promotions) Cup Holder Umbrella Holder Carrying Bag Seat Optional Accessories Rain Cover Sand Dispenser GPS Holder see "Special Offers" Introduced (year) 2009/2012 Warranty 1 Year on Parts and Labor 1 Year on Battery X3R
Timed forward advance function (10,20,30 yards) Cruise Control Power On/Off USB Port (optional) Distance/Range 13 mi(20 km)/27+ holes Climbing Ability 30 degrees Off-Power Free-Wheeling Mode Maximum Load 77 lbs (35 kg) Charger Input: 110-240V AC Output: 12V/3A-4A Trickle Charger Motor Power: 2 x 200 Watt (400 Watt) 12V DC Electric Front Wheels Airless, rubberized tread Tracking adjustment Rear Wheels Airless, rubberized tread Quick-release mechanism Anti-tip wheel assembly Drive Train Re
TROUBLESHOOTING GUIDE Symptom Caddy does not have power Motor is running but wheels don’t turn Caddy pulls to left or right Battery/Caddy lacks power Problems attaching wheels Action - Check all wiring connections and plugs - Check battery charge/ - Check On/Off button/switch - Check if wheels are secured to axle by split pin - Check right and left wheel position on X3/X3 Pro - Check right/left wheel clutches - Check if wheel is fitted over clutch & latched to axle - Check if axle pin i
FREQUENTLY ASKED QUESTIONS (FAQs) Please check our website at http://batcaddy.com/pages/FAQs.html for FAQs For Technical Support please contact one of our Service Centers. Contact info at http://batcaddy.com/pages/Contact-Us.html Check our website www.batcaddy.
