Bat-Caddy X3R™ Remote Controlled Electric Golf Caddy User Manual WARNING: PLEASE FOLLOW ALL ASSEMBLY INSTRUCTIONS AND READ AND UNDERSTAND THE OPERATING INSTRUCTIONS BEFORE YOU OPERATE THE CADDY, EITHER MANUALLY OR BY REMOTE CONTROL.
TABLE OF CONTENTS Page 1. 2. 3. 4. 5. 6. Packing List & Parts Glossary Assembly Instructions Operating Instructions General Maintenance & Other Instructions Technical Specifications Frequently Asked Questions 1.
1. 2. 3. 4. 5. 6. 7. Manual Rheostat Speed Control Upper Bag Support Bag Support Strap Battery Rear Wheel Wheel Hubcap Rear Wheel Quick Release Catch 8. 9. 10. 11. 12. 13. 14.
2. Assembly Instructions 1. Unpack all items carefully and check parts inventory. 2. Place frame structure (one piece) on soft and clean ground to protect frame from being scratched. Attach wheels to axles by pushing wheel locking button on the outside of the wheel and inserting the axle extension into the wheel.
. Insert anti tip wheel into holding bar on motor housing and secure with pin. 6. Install Scorecard Holder and other accessories, such as beverage or umbrella holder onto the frame or handle in the foreseen places or receptors. (note: accessory design might vary during the model year) 7. Unpack remote control and install two AAA batteries as indicated in the diagram in the receiver compartment of the unit.
3. Operating Instructions 3.1. Manual Operation 3.1.1. Power Switch The ON/OFF button (see illustration) controls the caddy’s main power supply. Once you have connected the battery, make sure that the rheostat speed control is in OFF position. Now press the button for ca. 2 seconds in order to switch the caddy ON or OFF (similar to a mobile phone operation). Now the battery charge indicator LEDs will illuminate, and your caddy is ready for operation. 3.1.2.
When your press 20M, the trolley will run 20 Meters/Yards and stop by itself When your press 30M, the trolley will run 30 Meters/Yards and stop by itself 3.1.4. Rheostat, Cruise Control and Brake/Stop Function : Easy scrolling action with the rheostat speed control knob on the handle lets you seamlessly choose your preferred speeds to suit your pace perfectly; To stop press the Cruise Control/Stop button.
3.2.2. Important Notes – PLEASE READ CAREFULLY Change the remote control batteries once the indicator LED gets weak The remote control uses two 1.5V AAA batteries available in any supermarket, drug store or electronics store It is recommended to keep a set of extra batteries ready as replacement To change the batteries open up the battery compartment cover and place the batteries according to the diagram in the battery compartment.
3.3. Additional Functions: 3.3.1. Freewheeling Mode The caddy can be easily operated without power. In order to activate the freewheeling mode, turn main power Off. The caddy now can be pushed manually without resistance. The freewheeling mode on some models can also be activated by pulling out both rear wheels by 1/2 inch (1cm) and relocking them back into the second axle groove. Some models are equipped with both options. 3.3.2.
hold the Forward or Reverse arrow button on the remote control until the indicator light flashes and simultaneously press the green button on the controller box and hold for ca. 6-10 seconds, repeating the process until the remote tunes in. Your caddy should now be “tuned” to the remote control. NOTE: It is recommended to remove the rear wheels or jack up the caddy before the synchronization process to prevent it from getting away. 3.3.3.
Attach seat stand to seat bottom using the four small screws. Attention: Attach in such manner that the seat points parallel to the driving direction of the caddy with the opening to the outside, once you slide it into the holding bar. Slide seat stand into holding bar as shown. Due to the spring mechanism the seat should reach the ground when pushed down. NOTE: Do NOT attempt to sit on the seat while trying to move the caddy or frame damage might occur! 4.
e) Please do not disassemble the battery or throw it into a fire. EXPLOSION!!! f) NEVER TOUCH THE ELECTRIC POLES OF THE BATTERY!! SAFETY HAZARD!! 4.1. Battery Charging & Maintenance Connect the battery cable plug with the charger and then plug the charger into an electrical outlet. During the charging cycle the LED on the charger will show a blinking green light (some charger models also have a red steady light during charging).
Pushing the wheel forward (clockwise) will control the forward movement of the caddy. In order to slow down or stop the caddy, turn the wheel backwards (counterclockwise). c. Remote Control Operation Make sure you are close to the caddy at all times while testing it and familiarizing yourself with the remote control!!! Now turn the caddy on, and make sure that the rheostat control wheel is in Off position. One touch of the Forward/Backward arrows on the remote control starts the caddy in either direction.
4.4. With its optimized balance and straight front wheel the caddy has extraordinarily narrow and responsive turning and maneuvering abilities. However, it sometimes tends to react to uneven weight distribution of its load or slope variations and will follow the weight and the slope of the golf course, which is normal for electric caddies.
All of these recommendations and common sense will help keep your Bat-Caddy in top condition and ensure that it remains your reliable partner, both on and off the links. 4.5. Electronic Systems Remote Control Range: We recommend not to exceed 20-50 yards distance from the caddy, ideally 10-30 yards.
5.
Rear Wheels Front Wheels Materials Colors Complimentary Accessories Height: 12" Airless, rubberized thread Airless, rubberized tread Frame: Aluminum, Stainless Steel Bag Support: ABS, Nylon Painted: Silver Scorecard Holder Cup Holder Seat Umbrella Holder Carrying Bag Rain Cover Sand Dispenser Laser Rangefinder Optional Accessories Warranty Packaging 1 Year on Caddy, Parts & Labor 6 months on Battery Type: Cardboard Box, Styrofoam or Cardboard Cushi
6. Frequently Asked Questions (FAQs) In order to provide our customers with the most accurate and in-depth information please read below some answers to the most frequently asked questions about electric golf caddies in general and the Bat-Caddy X3R in particular.
pace, despite the current economic climate. We are a global company represented in the US, Canada and Europe. BAT-CADDY QUESTIONS Should I charge the battery once I receive the unit? Bat-Caddy: Our 12V sealed lead acid batteries come more or less fully charged, but we recommend to charge them for a full 12 hours before the first usage. The charger should either have a blinking green light or a red light while it's charging and turn into a steady green light when the battery is fully charged.
until the remote tunes in and the caddy starts moving. Some models also have a green tuning button on the controller box located underneath the battery tray. To synchronize push the green button on the control box (either accessible through a hole underneath the battery tray or by removing the control box lid in the battery tray) while simultaneously pushing either the forward or reverse button on the new remote transmitter for ca. 10-20 sec.
