Operation Manual

27
EN
CHAIN
LUBRICANT
Fig. 5
OIL
RESERVOIR
CAP
QUICK VIEW
OIL INDICATOR
• Replace the cap and tighten securely
• Wipe off excess lubricant
• Check and fill the oil tank when quick view
oil indicator is below the MIN indicator line
• Check the tank every time the lopper is
used
• Repeat as needed
NOTE: Do not use dirty, used, or otherwise
contaminated lubricants. Damage may occur
to the bar or chain.
NOTE: It is normal for oil to seep from the saw
when not in use. To prevent seepage, empty
the oil tank after each use then run for one
minute. When storing the unit for a long period
of time (three months of longer) be sure the
chain is lightly lubricated; this will prevent rust
on the chain and bar sprocket.
CONNECTING TO POWER SUPPLY
See Figure 6.
This product is designed with a cord retainer
that prevents the extension cord from being
pulled loose while using.
LOCK-OUT
BUTTON
SWITCH TRIGGER
CORD RETAINER
Fig. 6
NOTICE: Always use cord retainer to properly
attach extension cord to lopper. Failure to use
cord retainer may result in damage to lopper
and/or extension cord.
• Form a loop with the end of the extension
cord
• Insert loop portion of extension cord
through opening in the bottom of the rear
handle and place over cord retainer
• Slowly pull loop against cord retainer until
the slack is removed
• Plug product into extension cord
NOTE: Failure to remove all excess cord slack from
extension cord retainer could result in plug loosening
from receptacle.
STARTING AND STOPPING
See Figure 6.
To start the motor:
• Connect the lopper to power supply
• Use your thumb to depress the lock-out
button and fully depress the switch trigger
To stop the motor:
• Release the switch trigger
HOLDING THE LOPPER
See Figure 7.
Croc Saw Manual.indb 27 24-04-14 11:18