Operation Manual

TM
GUIDE BAR
A bar with any of the following fault should be
replaced.
• Wear inside the bar rails which permits the
chain to lay over sideways.
• Bent guide bar.
• Cracked or broken rails
• Spread rails
Lubricate guide bars with a sprocket at their tip
weekly. Using a grease syringe, lubricate
weekly in the lubricating hole. Turn the guide
bar and check that the lubrication holes and
chain groove are free from impurities.
STORING THE PRODUCT
• Disconnect from power supply and store
out of the reach of children.
• Clean all foreign material from the product.
Store idle unit indoors in a dry, well-
ventilated area that is inaccessible to
children. Keep away from corrosive agents
such as garden chemicals and de-icing
salts.
TROUBLESHOOTING
PROBLEM
• Bar and chain running hot and smoking.
CAUSE
• Check chain tension for over tightened
condition.
• Oil reservoir empty.
REMEDY
• Tension chain. Refer to Chain Tension
earlier in this manual.
• Check oil reservoir.
PROBLEM
• Motor runs, but chain is not rotating
CAUSE
• Chain tension too tight.
• Check guide bar and chain assembly.
• Check guide bar and chain for damage.
REMEDY
• Retention chain. Refer to Chain Tension
earlier in this manual.
• Refer to Replacing the Bar and Chain
earlier in this manual.
• Inspect guide bar and chain for damage.
TECHNICAL DATA
• Chain Lubricant
Tank Capacity:
• Bar Length:
• Cutting capacity:
• Chain type:
• Input:
• Weight:
55 ml
203 mm
Ø10 cm
Low prole skip tooth
narrow kerf
600 w
3.8 kg
DISPOSAL
Do not dispose of electric power
tools with domestic refuse.
The electric power tool is shipped in
packaging to reduce transport damage.
This packaging is a raw material and as
such can either be reused or can be fed
back into the raw material cycle. The electric
power tool and its accessories are made
from various materials such as metals and
plastics. Take defective components to a
special refuse collection point. Ask about
these at your specialist shop or local council.
32
Croc Saw Manual.indb 32 24-04-14 11:18